Cisco Cisco Aironet 350 Access Points 發佈版本通知
2
Release Notes for Cisco Aironet Conversion Upgrade Image for Cisco IOS Software for Cisco Aironet 350 Series Access Points
OL-5175-01
Introduction
Introduction
The Cisco IOS Conversion Upgrade Image for Cisco Aironet 350 Series Access Points converts a 350
series access point system from VxWorks software to Cisco IOS Release 12.2(13)JA1.
series access point system from VxWorks software to Cisco IOS Release 12.2(13)JA1.
When you use the upgrade image with the Cisco Aironet Conversion Tool for Cisco IOS Software, the
upgrade image and the conversion tool maintain the access point configuration while converting the
access point system to IOS operation. When you load the upgrade image onto an access point without
using the conversion tool, the upgrade image converts the access point system to IOS software with all
settings at factory defaults.
upgrade image and the conversion tool maintain the access point configuration while converting the
access point system to IOS operation. When you load the upgrade image onto an access point without
using the conversion tool, the upgrade image converts the access point system to IOS software with all
settings at factory defaults.
System Requirements
Your 350 series access point must run one of these VxWorks firmware versions to use the upgrade image:
12.03T, 12.02T1, 12.01T1, 12.00T, 11.23T, and 11.21
Note
The upgrade image and the conversion tool do not support VxWorks version 12.04. Access points
running operating system version 12.04 must be downgraded to a supported operating system version
before using the upgrade image or the conversion tool.
running operating system version 12.04 must be downgraded to a supported operating system version
before using the upgrade image or the conversion tool.
Note
Cisco Aironet 340 Series Access Points do not support IOS software. Do not attempt to load the upgrade
image on 340 series access points.
image on 340 series access points.
Finding the Software Version
On 350 series access points that do not run IOS software, the software version appears in red at the top
left of most pages in the web-browser interface. The home page on access points not running IOS
software looks like the page in
left of most pages in the web-browser interface. The home page on access points not running IOS
software looks like the page in
.
Figure 1
Home Page on Access Points not Running Cisco IOS Software