Cisco Cisco Gigabit Ethernet Switch Module (CGESM) for HP 發佈版本通知
13
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(25)SEE1 and later
459516-002
Documentation Notes
By default, VLAN 1 is the interface that connects to the management network. When the switch boots
up, the DHCP client (switch) requests an IP address from a DHCP server by using the MAC address of
VLAN 1.
up, the DHCP client (switch) requests an IP address from a DHCP server by using the MAC address of
VLAN 1.
Documentation Notes
This section describes documentation notes related to this IOS release.
References to IOS Release Number
These documents refer to Release 12.2(25)SE. The correct release is Release 12.2(25)SE1.
•
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Software Configuration Guide,
Cisco IOS Release 12.2(25)SE
Cisco IOS Release 12.2(25)SE
•
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Command Reference Guide,
Cisco IOS Release 12.2(25)SE
Cisco IOS Release 12.2(25)SE
•
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class System Message Guide, Cisco
IOS Release 12.2(25)SE
IOS Release 12.2(25)SE
Open Caveats
These sections describe the open caveats with possible unexpected activity in this software release:
•
•
Open IOS Caveats
These severity 3 Cisco IOS configuration caveats apply to the CGESM switch:
•
CSCee08109
If a port-based ACL (PACL) is applied to an 802.1x-enabled port and the client is then disconnected
from that port, the PACL is not removed from the port.
from that port, the PACL is not removed from the port.
There is no workaround.
•
CSCee22376
When an SNMP version 3 user is configured with the encrypted option and password, the switch
reloads when the MIB object usmUserAuthKeyChange is set.
reloads when the MIB object usmUserAuthKeyChange is set.
The workaround is to configure a user without the encrypted option. (For example, snmp-server
user username groupname v3 auth md5 password.)
user username groupname v3 auth md5 password.)
•
CSCeg04311
When you power on or restart a switch that does not have a config.text file in flash memory, the
switch tries to get configuration files from a TFTP server. If the configuration files are not found,
the switch automatically configures the service config global configuration command, which causes
the switch to continue searching (in the background) for the expected configuration files.
switch tries to get configuration files from a TFTP server. If the configuration files are not found,
the switch automatically configures the service config global configuration command, which causes
the switch to continue searching (in the background) for the expected configuration files.