Cisco Cisco Gigabit Ethernet Switch Module (CGESM) for HP 發佈版本通知

rQm 266129

If you power on a switch that does not have a config.txt file (the factory default file) and leave the 
switch on for few hours, the switch console appears to be stalled during setup. 

The workaround is to reload the switch before you continue to configure it. 

This is the severity 3 device manager caveat for this release:

CSCef94061

If you enter the letter i by itself in the port description, the VLAN status column displays i; this only 
occurs when you are using Device Manager through Netscape 7.1.

The workaround is to run Device Manager through Internet Explorer if you must enter a port 
description with only the value “i.”

This sections describes the caveats that have been resolved in these releases:

The are the resolved caveats in Cisco IOS Release 12.2(35)SE5:

CSCed87897 

The output of the show ip route privileged EXEC command now correctly displays the default 
gateway. 

CSCsh89429

The switch no longer reloads when the write core privileged EXEC command is entered when testing 
a core dump configuration and FTP is selected as the file transfer protocol.

CSCsi74508

A switch no longer displays this error message when reading from or writing to the configuration 
file:

%DATACORRUPTION-1-DATAINCONSISTENCY: write of 11 bytes to 10 bytes 

-Traceback= 0x41186A90 0x411A3960 0x411C1F88 0x413C24B8 0x4031EEDC 0x4032D144 

0x411C3974 0x41193D9C 0x4119420C 0x411DF55C 0x411C70AC 0x411E3184 0x425590F4

0x4254BD7C 0x421B5CE0 0x421B5CC4

CSCsi94450

When DHCP snooping is enabled on a VLAN, the broadcast DHCP request is now correctly sent 
over the trusted port and the connected hosts correctly receive their IP addresses.