Cisco Cisco Firepower Management Center 2000 安装指南

Set the MTU size for every circuit (including template circuits) in the VAP group. For example:

CBS# configure circuit circuit_name

CBS(conf-cct)# vap-group vap_group_name

CBS(conf-cct-vapgroup)# mtu

 

CBS(conf-cct-vapgroup)# end

CBS#

where 

 is the name of the circuit, 

 is the name of the VAP group and

 

 is the MTU size. For example, to set the MTU to 9000 on the circuit named 

n6g7

 

on a VAP 

group named 

ABC

, enter the following:

CBS# configure circuit n6g7

CBS(conf-cct)# vap-group ABC

CBS(conf-cct-vapgroup)# mtu 9000

CBS(conf-cct-vapgroup)# end

CBS#

You must configure both circuits in a bridge with identical MTU sizes.

To complete the process of enabling jumbo frame support, reload the VAP group by entering the 
following:

CBS# reload vap-group vap_group_name

where 

 is the name of the VAP group.

For more information, see the XOS Command Reference Guide.

To install Cisco NGIPS for Blue Coat X-Series, you must perform the following steps: 

Transfer the application to the Control Processor Module (CPM), as described in 

Install and configure the application on the VAP groups, as described in 

.

Verify the installation, as described in 

In this section, the Cisco NGIPS for Blue Coat X-Series package displays 

3D Sensor

 

on the monitor as 

the application name of the Cisco NGIPS for Blue Coat X-Series application. It is not the name you give 
the device, VAP, or VAP groups you create.

https://support.sourcefire.com/

) and check for updates to the FireSIGHT System, which you can apply 

using the Defense Center. The release notes accompanying each update include instructions for 
installing the new software.

After you set up VAP groups and circuits, load Cisco NGIPS for Blue Coat X-Series onto the X-Series 
Control Processor Module (CPM).