Cisco Cisco IOS Software Release 12.4(4)T 發佈版本通知

Example output when detection and recovery code on gateway triggers:

*May 31 14:30:43.343: TDM pointers: 0100 0100 0115 0115. Deltas: 0001 0000.

*May 31 14:30:43.347: Received alarm indication from dsp(0/1)

0030 0000 0080 0000 0013 4100 2E2E 2F2E 2E2F 6D6F 6475 6C65 732F 7363 6865 6475 6C65 

2F64 6562 7567 2E63 2833 3634 2900 

*May 31 14:30:43.347: ../../modules/schedule/debug.c(364)

*May 31 14:30:43.347: %LINK-3-UPDOWN: Interface Foreign Exchange Office 0/0/0, 

changed state to Administrative Shutdown

*May 31 14:30:43.647: %LINK-3-UPDOWN: Interface Foreign Exchange Office 0/0/1, 

changed state to Administrative Shutdown

*May 31 14:30:43.947: %LINK-3-UPDOWN: Interface Foreign Exchange Office 0/0/2, 

changed state to Administrative Shutdown

*May 31 14:30:44.247: %LINK-3-UPDOWN: Interface Foreign Exchange Office 0/0/3, 

changed state to Administrative Shutdown

*May 31 14:30:48.147: Crash dump CLI may not be configured, not able to get crash 

info, slot 0, dsp 1

*May 31 14:30:48.147: DSPDUMP - Recover slot 0 dsp 1

*May 31 14:30:48.147: DSPDUMP - ka sent 0, ka_cnt 51193, skip_ka 103079

*May 31 14:30:50.579: %DSPRM-5-UPDOWN: DSP 1 in slot 0, changed state to up

*May 31 14:30:50.947: %LINK-3-UPDOWN: Interface Foreign Exchange Office 0/0/0, 

changed state to up

*May 31 14:30:51.219: %LINK-3-UPDOWN: Interface Foreign Exchange Office 0/0/1, 

changed state to up

*May 31 14:30:51.371: %LINK-3-UPDOWN: Interface Foreign Exchange Office 0/0/2, 

changed state to up

*May 31 14:30:51.523: %LINK-3-UPDOWN: Interface Foreign Exchange Office 0/0/3, 

changed state to up

----

Following are command output examples:

Following is an example of normal output for FXO and EVM FXS ports.

For FXO ports, the value is usually 0x01 but for EVM FXS the value can be different. When 
you run the above-mentioned command, the expected output is that a single octet is displayed 
and only for register 39. (This command does not work for VIC-4FXS and VIC2-xFXS 
modules).

router#term mon

router#test voice port 0/3/3 si-reg-read 39 1

router#

Values read from SiLabs Codec connected to DSP 0, channel 11:

--------------------------------------------------------------

Register 39 = 0x01