Cisco Cisco IOS Software Release 12.4(4)T 發佈版本通知
1384
Caveats for Cisco IOS Release 12.4T
OL-8003-09 Rev. Z0
Resolved Caveats—Cisco IOS Release 12.4(2)T5
2.
Following is an example of output for FXO and EVM FXS ports that indicates that the symptom
has occurred. Note that the exact output for the register values is different, but when the
symptom occurs, different lines with information are displayed as shown below:
has occurred. Note that the exact output for the register values is different, but when the
symptom occurs, different lines with information are displayed as shown below:
router#term mon
router#test voice port 0/3/3 si-reg-read 39 1
router#
Values read from SiLabs Codec connected to DSP 0, channel 11:
--------------------------------------------------------------
Register 39 = 0x5CB8
Register 40 = 0xFFFF
Register 41 = 0xFFFF
Register 42 = 0xFFFF
3.
Following is an example of normal output for FXS and analog E&M modules. The values that
are listed in a normal case may be different, but only four registers of a single octet should be
displayed.
are listed in a normal case may be different, but only four registers of a single octet should be
displayed.
Values read from PEB2465 Codec connected to DSP 02 (channel 0):
---------------------------------------------------------------
Extended Register Values (XR4..XR1) = 00, CC, 50, 11
4.
Following is an example of output for FXS and analog E&M modules that indicates that the
symptom has occurred.
symptom has occurred.
Values read from PEB2x65 Codec connected to DSP 0, channel 1:
------------------------------------------------------------
Extended Register Values (XR4..XR1) = D001, B83C, 3FF1, 63AC
Wide-Area Networking
•
CSCeg77994
Symptoms: A LAC does not send an Accounting-Start RADIUS record to a RADIUS server for a
user session.
user session.
Conditions: This symptom is observed on a Cisco platform that functions as a LAC and that runs
Cisco IOS Release 12.3(14)T1 when a switchover occurs from one LNS to another LNS while the
user session is brought up.
Cisco IOS Release 12.3(14)T1 when a switchover occurs from one LNS to another LNS while the
user session is brought up.
Workaround: There is no workaround.
•
CSCek28575
Symptoms: A router reloads at the “process_modem_command” function during a test that involves
asynchronous media.
asynchronous media.
Conditions: This symptom is observed on a Cisco AS5400 but is not platform-dependent.
Workaround: There is no workaround.
•
CSCsc17673
Symptoms: Using the show caller full or show caller interface Virtual-Access XX full commands
on a PPPoE client interface causes the router to unexpectedly reload.
on a PPPoE client interface causes the router to unexpectedly reload.
Conditions: This symptom has been observed on routers using Cisco IOS Release 12.4(3.3) and
later versions.
later versions.