Cisco Cisco IOS Software Release 12.2(35)SE 發佈版本通知

(Optional) Ensure that you have IP connectivity to the TFTP server by entering this privileged EXEC 
command:

Switch# ping tftp-server-address

For more information about assigning an IP address and default gateway to the switch module, see the 
software configuration guide for this release. 

Download the image file from the TFTP server to the switch module. If you are installing the same 
version of software that is currently on the switch module, overwrite the current image by entering this 
privileged EXEC command:

Switch# archive download-sw /overwrite /reload 

[[//location]/directory]/image-name.tar

The /overwrite option overwrites the software image in flash memory with the downloaded one. 

The /reload option reloads the system after downloading the image unless the configuration has been 
changed and not saved.

For //location, specify the IP address of the TFTP server.

For /directory/image-name.tar, specify the directory (optional) and the image to download. Directory 
and image names are case sensitive.

This example shows how to download an image from a TFTP server at 198.30.20.19 and to overwrite 
the image on the switch module:

Switch# archive download-sw /overwrite 

You can also download the image file from the TFTP server to the switch module and keep the current 
image by replacing the /overwrite option with the /leave-old-sw option.

For additional recovery procedures, see the “Troubleshooting” chapter in the software configuration 
guide for this release.

You can assign IP information to your switch module by using the IBM advanced Management Module 
software and the switch module device manager Express Setup program, as described in the switch 
module getting started guide.