Cisco Cisco IOS Software Release 12.2(35)SE 發佈版本通知
5
Release Notes for Cisco Catalyst Switch Module 3110G, 3110X, and 3012 for IBM BladeCenter, Cisco IOS Release 12.2(40)EX2
OL-12193-01
Upgrading the Switch Module Software
Note
Although the show version output always shows the software image running on the switch module, the
model name at the end of this display is the factory configuration (IP base feature set or IP services
feature set). It does not change if you upgrade the software license.
model name at the end of this display is the factory configuration (IP base feature set or IP services
feature set). It does not change if you upgrade the software license.
You can also use the dir filesystem: privileged EXEC command to see the directory names of other
software images that you might have stored in flash memory.
software images that you might have stored in flash memory.
Deciding Which Files to Use
The upgrade procedures in these release notes describe how to perform the upgrade by using a combined
tar file. This file contains the Cisco IOS image file and the files needed for the embedded device
manager. You must use the combined tar file to upgrade the switch module through the device manager.
To upgrade the switch module through the command-line interface (CLI), use the tar file and the archive
download-sw or archive download privileged EXEC command.
tar file. This file contains the Cisco IOS image file and the files needed for the embedded device
manager. You must use the combined tar file to upgrade the switch module through the device manager.
To upgrade the switch module through the command-line interface (CLI), use the tar file and the archive
download-sw or archive download privileged EXEC command.
lists the filenames for this software release.
Note
For IPv6 routing and IPv6 ACL capability on the switch module, you must get the advanced IP services
software license from Cisco (only Catalyst Switch Module 3110G and 3110X).
software license from Cisco (only Catalyst Switch Module 3110G and 3110X).
The universal software images support multiple feature sets. Use the software activation feature to
deploy a software license and to enable a specific feature set. For information about software activation,
see the Cisco Software Activation and Compatibility Document on Cisco.com:
deploy a software license and to enable a specific feature set. For information about software activation,
see the Cisco Software Activation and Compatibility Document on Cisco.com:
Archiving Software Images
Before upgrading your switch module software, make sure that you have archived copies of the current
Cisco IOS release and the Cisco IOS release from which you are upgrading. You should keep these
archived images until you have upgraded all network devices to the new Cisco IOS image and until you
have verified that the new Cisco IOS image works properly.
Cisco IOS release and the Cisco IOS release from which you are upgrading. You should keep these
archived images until you have upgraded all network devices to the new Cisco IOS image and until you
have verified that the new Cisco IOS image works properly.
You can copy the bin software image file on the flash memory to the appropriate TFTP directory on a
host by using the copy flash: tftp: privileged EXEC command.
host by using the copy flash: tftp: privileged EXEC command.
Table 5
Cisco IOS Software Image Files for Catalyst Switch Modules
Filename
Description
cbs31x0-universal-tar.122-40.EX2.tar
Catalyst switch module universal image and device manager files. This image has
all the supported features that are enabled by the software license installed on the
switch module.
all the supported features that are enabled by the software license installed on the
switch module.
cbs31x0-universalk9-tar.122-40.EX2.tar Catalyst switch module universal cryptographic image and device manager files.
This image has the Kerberos, SSH, SSL, and SNMPv3 in addition to the features
supported in the universal image.
supported in the universal image.