Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point 安装指南
14
Cisco Aironet 1520 Series Outdoor Mesh Access Point Mounting Instructions
78-18269-04
Installation Guidelines
shows the antenna port locations viewed from the hinged cover side.
Figure 5
Antenna Port Locations
Adding the Access Point MAC Addresses to the Controller Filter List
Before installing your access points, configure your controller by adding the MAC addresses of the
access points to the filter list. MAC address filtering is enabled by default. This enables the controller to
respond to the listed access points. Follow these steps to add a MAC filter entry on the controller:
access points to the filter list. MAC address filtering is enabled by default. This enables the controller to
respond to the listed access points. Follow these steps to add a MAC filter entry on the controller:
Step 1
Log into your controller using a web browser.
Step 2
Choose SECURITY > MAC Filtering > New.
Step 3
Enter the MAC address of the access point to the MAC Filter list; for example, 00:0B:91:21:3A:C7.
Note
The access point MAC address is located on the bottom of the unit. When two MAC addresses
are shown, use the top MAC address.
are shown, use the top MAC address.
Step 4
Select a WLAN ID or Any WLAN from the WLAN ID pop-up menu.
Step 5
Enter a description (32 characters maximum) of the access point in the Description field; for example,
Fisher_Street_00.0B.91.21.3A.C7 shows the location and MAC address of the access point.
Fisher_Street_00.0B.91.21.3A.C7 shows the location and MAC address of the access point.
Step 6
Choose an interface from the Interface Name pop-up menu, and click Apply.