Cisco Cisco Industrial Wireless 3702 Access Point 安装指南
13
Cisco IW3702 Access Point Getting Started Guide
Installation
EMC Environmental Conditions for Products Installed in the European Union
This section applies to products installed in the European Union. The equipment is intended to operate under the
following environmental conditions with respect to EMC:
following environmental conditions with respect to EMC:
A separate defined location under the user’s control.
Earthing and bonding meets the requirements of ETSI EN 300 253 or ITU-T K.27.
AC-power distribution shall be one of the following types, where applicable: TN-S and TN-C as defined in IEC
60364-3.
60364-3.
In addition, if equipment is operated in a domestic environment, interference could occur.
National Restrictions within the European Union
Within the European Union as well as within the majority of the other European Countries, the 2.4 and 5 GHz bands are
available for use by wireless LANs.
available for use by wireless LANs.
provides an overview of the regulatory requirements that are generally applicable for 2.4 and 5 GHz
bands.
The requirements for any country might evolve. We recommend that you check with your local authorities for the current
status of regulations for 2.4 and 5 GHz wireless LANs within your country.
status of regulations for 2.4 and 5 GHz wireless LANs within your country.
Tools and Hardware Required
These tools and hardware are required for access point installation:
Crimping tool (such as Thomas & Bett part number WT2000, ERG-2001, or equivalent)
6-gauge copper ground wire
Wire-stripping tools for stripping 6-gauge wire
Number 2 Phillips screwdriver
1/2" (13 mm) socket for port plug
5/8" (16 mm) socket for protective vent
5/32" (4 mm) hex key for mounting screws
Torque wrench (both inch-lbs and ft-lbs)
Installation Guidelines
Because the access point is a radio device, it is susceptible to common causes of interference that can reduce
throughput and range. Follow these guidelines to ensure the best possible performance:
throughput and range. Follow these guidelines to ensure the best possible performance:
Table 3
Overview of Regulatory Requirements for Wireless LANs
Frequency Band (MHz)
Maximum Power Level Effective
Isotropic Radiated Power (EIRP) mW
Isotropic Radiated Power (EIRP) mW
Indoor only
Indoor and Outdoor
2400-2483.5
100
—
x
5150-5350
200
x
—
5470-5725
1000
—
x