Cisco Cisco Web Security Appliance S360 安装指南

1-8

Cisco x90 Series Content Security Appliances Installation and Maintenance Guide

Chapter 1 Installing Cisco x90 Series Content Security Appliances

Installing Cisco x90 Series Content Security Appliances In a Rack

Step 5

(Optional) Secure the appliance in the rack more permanently by using the two screws that are provided
with the slide rails. Perform this step if you plan to move the rack with appliances installed.

With the appliance fully pushed into the slide rails, open a hinged slam latch lever on the front of the
appliance and insert the screw through the hole that is under the lever. The screw threads into the static
part of the rail on the rack post and prevents the appliance from being pulled out. Repeat for the opposite
slam latch.

Installing the Cable Management Arm (Optional)

Note

The Cable Management Arm (CMA) is reversible left to right. To reverse the CMA, see

Reversing the Cable Management Arm (Optional), page 1-9

before installation.

Step 1

With the appliance pushed fully into the rack, slide the CMA tab of the CMA arm that is farthest from
the appliance onto the end of the stationary slide rail that is attached to the rack post (see

Figure 1-6

Slide the tab over the end of the rail until it clicks and locks.

Step 2

Slide the CMA tab that is closest to the appliance over the end of the inner rail that is attached to the
appliance (see

Figure 1-6

). Slide the tab over the end of the rail until it clicks and locks.

Step 3

Pull out the width-adjustment slider that is at the opposite end of the CMA assembly until it matches the
width of your rack (see

Figure 1-6

Step 4

Slide the CMA tab that is at the end of the width-adjustment slider onto the end of the stationary slide
rail that is attached to the rack post (see

Figure 1-6

). Slide the tab over the end of the rail until it clicks

and locks.

Step 5

Open the hinged flap at the top of each plastic cable guide and route your cables through the cable guides
as desired.