Cisco Cisco Aironet 1200 Access Point 發佈版本通知
5
Limitations and Restrictions
OL-3159-01
Limitations and Restrictions
Limitations and Restrictions
This section describes limitations and restrictions for 1200 series access points.
Removing Power During Firmware Update Can Corrupt Radio Firmware
When you update the firmware on an access point, allow the unit to finish its start-up sequence before
removing power. If you update the firmware and remove power before the unit finishes the start-up
sequence, the radio firmware might be corrupted, making the unit inoperable. If the radio firmware is
corrupted, the radio indicator (the bottom of the three indicators on top of the access point) is red
continuously, and the following error message appears when the access point starts up:
removing power. If you update the firmware and remove power before the unit finishes the start-up
sequence, the radio firmware might be corrupted, making the unit inoperable. If the radio firmware is
corrupted, the radio indicator (the bottom of the three indicators on top of the access point) is red
continuously, and the following error message appears when the access point starts up:
Failed to start driver for port “awc0” (errno=0x006d0002)
The access point should recover from this error automatically.
You can safely remove power after a firmware update when the configuration management pages
reappear in the command-line or web-browser interfaces, or when the three status indicators on top of
the unit complete the following pattern:
reappear in the command-line or web-browser interfaces, or when the three status indicators on top of
the unit complete the following pattern:
1.
All three indicators are continuously green, meaning that the access point is beginning to update the
firmware.
firmware.
2.
The middle indicator is continuously green and the top and bottom indicators are off, indicating that
the access point is updating the radio firmware.
the access point is updating the radio firmware.
When the middle indicator blinks or the top and bottom indicators blink, you can remove power.
EAP Authentication Requires Matching 802.1x Protocol Drafts
Note
This section applies to wireless networks set up to use LEAP. If you do not use LEAP on your
wireless network, you can skip this section.
wireless network, you can skip this section.
Wireless client devices use Extensible Authentication Protocol (EAP) to log onto a network and generate
a dynamic, client-specific WEP key for the current logon session. If your wireless network uses WEP
without EAP, client devices use the static WEP keys entered in the Aironet Client Utilities.
a dynamic, client-specific WEP key for the current logon session. If your wireless network uses WEP
without EAP, client devices use the static WEP keys entered in the Aironet Client Utilities.
If you use Network-EAP authentication on your wireless network, your client devices and access points
must use the same 802.1x protocol draft. For example, if the radio firmware on the client devices that
will associate with an access point is 4.16, the access point should be configured to use Draft 8 of the
802.1x protocol.
must use the same 802.1x protocol draft. For example, if the radio firmware on the client devices that
will associate with an access point is 4.16, the access point should be configured to use Draft 8 of the
802.1x protocol.
lists firmware versions for Cisco Aironet products and the draft with which they
comply.
Table 1
802.1x Protocol Drafts and Compliant Client Firmware
Firmware Version
Draft 7
Draft 8
Draft 10
1
PC/PCI cards 4.13
—
x
—
PC/PCI cards 4.16
—
x
—
PC/PCI cards 4.23
—
x
—