Cisco Cisco Evolved Programmable Network Manager 1.2 安装指南
15
•
DHCP—Disable DHCP if enabled.
•
CIMC IP—Enter the IP address of the CIMC.
•
Prefix/Subnet—Enter the subnet of the CIMC.
•
Gateway—Enter the Gateway address.
•
Pref DNS Server—Enter the preferred DNS server address.
•
NIC Redundancy—Null
Step 10
Press F1 to view the additional settings.
Step 11
In the Additional Settings window, update the following fields:
•
Hostname—Enter hostname for the CIMC.
•
Dynamic DNS—Disable.
•
Enter the admin password. If you leave the Password blank, the default password is password.
Step 12
Press F10 to save the settings.
Step 13
Open a browser and enter https://CIMC_ip_address, where CIMC_IP_address is the CIMC IP address that you entered
in
in
.
Step 14
Log in to the CIMC using the credentials given in
. You will be prompted to reset the password if you did not
change the default password in
Step 15
Configure the UCS Bare-Metal server, see
Configure the Bare-Metal UCS Server
To configure the Bare-Metal UCS server:
Step 1
Launch the CIMC web interface.
Step 2
From the left sidebar, click the Storage tab, and then click the Cisco 12G SAS Modular Raid Controller (SLOT-HBA)
link.
link.
Step 3
In the Cisco 12G SAS Modular Raid Controller (SLOT-HBA) pane, click the Controller Info tab.
Step 4
In the Actions area, click the Create Virtual Drive from Unused Physical Drives link.
Step 5
In the Create Virtual Drive from Unused Physical Drives window, from the RAID Level drop-down list, choose 10.
Step 6
In the Create Drive Groups area, select the physical drives listed under the Physical Drives area and add the selected
drives to the Drive Groups.
drives to the Drive Groups.
Step 7
In the Virtual Drive Properties area, from Write Policy drop-down list, choose Write Back Good BBU.
Step 8
Complete the required fields, and then click Create Virtual Drive.
Step 9
In the Create Virtual Drive from Unused Physical Drives window, click the Virtual Drive Info tab.
Step 10
Click Initialize.A popup window is displayed.
Step 11
Click Initialize VD.
Step 12
Follow the steps below to enable Auto-Negotiation to speed up the installation:
a.
From the left sidebar, click the Admin tab.
b.
On the Admin tab, click Network.
c.
In the Network pane, click the Network Settings tab.
d.
In the Port Properties area, check the Auto Negotiation check box.
e.
Click Save Changes.
Step 13
From the left sidebar, click the Admin tab.
Step 14
Click Utilities pane, in the Actions area, click Reboot CIMC.
Step 15
Click OK.