Cisco Headend System Release 2.5 设计指南
Chapter 1 Before You Activate SBE
4
740029 Rev B
11 Contact your billing provider and ask them to enable the DIS flag on billing
transactions being sent to the DNCS.
12 After billing enables the DIS flag on transactions, repeat steps 2 through 8 on a
test group DHCT to verify that billing has enabled the DIS flag.
13 Does a check mark appear in the DIS Enable field?
If yes, then the billing system is setting the DIS enable flag.
If no, you must contact your billing provider to have them enable the DIS flag
on billing transactions being sent to the DNCS.
14 Repeat steps 12 and 13 on the other two DHCTs in your test group to verify that
the DIS Enable flag is being set.
15 Click Cancel to close the Set Up DHCT window and return to the DHCT
Provisioning window.
16 Click Cancel to close the DHCT Provisioning window and return to the DNCS
Administrative Console.
Check Recently-Staged DHCTs
After you verify that your billing provider is enabling the DIS flag on billing
transactions to the DNCS, test a few recently-staged DHCTs to ensure that the DIS
Enable flag is being received.
Special Case: SSC CableCARD Set-Top Boxes
Setting the DIS flag to enabled when loading SSC set-top boxes will cause binding
Setting the DIS flag to enabled when loading SSC set-top boxes will cause binding
and staging problems. Instead, stage them without special flags enabled, enable DIS
after staging is complete, and send a Hit in order to obtain Type 8 EMMs.
WARNING:
Do not enable DIS in billing on SSC CableCARD set-top boxes.
Do not use CableCARD set-top boxes for DIS flag testing purposes.
Ensure the DIS Flag is Enabled
Complete the following steps to perform Test Two on a few recently-staged DHCTs.
Complete the following steps to perform Test Two on a few recently-staged DHCTs.
1. On the DNCS Administrative Console, click the DNCS tab.
2. Click one of the following tabs:
2. Click one of the following tabs:
If you are using SR 4.2 and later, click Home Element Provisioning.
If you are using SR 4.0 and earlier, click Element Provisioning.
3. Click DHCT. The DHCT Provisioning window appears.
4. In the Select Option area, click the Open option, if it is not already selected.
4. In the Select Option area, click the Open option, if it is not already selected.