Cisco Headend System Release 2.5 用户指南
Chapter 3 Generating Reports
20
4021181 Rev B
Generating SNMP Poll Reports
1 From the DNCS/ISDS Reports page, click SNMP Poll Reports.
Note: SNMP Poll Reports are not applicable to i4.2 or IP-only environments.
2 Click the hyperlink of one of the SNMP Poll Reports.
3 Does the report appear on the screen?
3 Does the report appear on the screen?
If yes, the data is from the last run of the SNMP Poll Report. Click Back to
return to the SNMP Poll Reports page; then click Run Report to refresh the
report data.
If no, go to step 4.
4 Does the following message appear on the screen?
This report has not yet been generated on your system. Please press the back
button on your browser to return to the SNMP page.
If yes, click Back to return to the SNMP Poll Reports page.
If no, click Run Report to generate all of the SNMP Poll Reports.
Important: The SNMP Poll Reports can take a significant amount of time to
complete, depending on the number of DHCTs in the system. While the SNMP
Poll Reports are being generated, do not exit your web browser. Exiting the web
browser while the reports are being generated can cause errors in the Report
Writer software that will require some manual clean-up steps (see
Troubleshooting Guidelines and Solutions (on page 25)). It is also recommended
that you do not click anywhere in your web browser until the SNMP Poll
Reports are completely generated.