Cisco Headend System Release 2.7 故障排查指南
Conduct Scheduled Weekly and Monthly Tests
4024428 Rev B
61
Conduct Scheduled Weekly and Monthly Tests
This section provides a table of the requirements, methods, and procedures for
conducting the RWT and the RMT on each EAS.
Important: You must configure your system so that the RMT always functions in
Important: You must configure your system so that the RMT always functions in
automatic mode. The FCC conducts the RMTs.
Note: You can configure your system so that the RWT always functions in automatic
Note: You can configure your system so that the RWT always functions in automatic
mode or you can set up the RWT to run in manual mode. See Test the EAS from the
ISDS (on page 54) for information on sending and terminating ad hoc EAS messages.
Conducting Weekly and Monthly Tests
Use the following table to find your EAS equipment manufacturer, and follow the
instructions provided for your system. Refer to the documentation for your specific
EAC for additional information on conducting the RWT and the RMT.
Important: If your system does not function as expected, refer to
Important: If your system does not function as expected, refer to
Troubleshooting
(on page 63) for troubleshooting procedures for the EAS.
System
RWT
RMT
Megahertz
Automatic Mode:
Automated process
Manual Mode:
Automated process
Manual Mode:
Press the Week soft key.
Enter your password.
Press the Proceed soft key.
Automatic Mode:
Automated process
Manual Mode:
The FCC requires that the RMT
Automated process
Manual Mode:
The FCC requires that the RMT
function in automatic mode.
Trilithic
Automatic Mode:
Automated process
Manual Mode:
Not available
Automated process
Manual Mode:
Not available
Automatic Mode:
Automated process
Manual Mode:
The FCC requires that the RMT
Automated process
Manual Mode:
The FCC requires that the RMT
function in automatic mode.