Cisco Model 6109 6 MHz Off-Air Reference (NTSC) 安装指南
USRM Web Interface - Resource Manager
4039132 Rev B
209
Parameters
The following table explains the ResourceManager - QAM - Chassis page
parameters.
parameters.
Parameter
Description
ProductType
The type of edge device. An edge device is supported
through the use of a resource model and resource
adaptor. This column contains the name of the resource
model for this edge device, e.g., GQAM, xDQA24,
TableQam, NSG8108, SEM, D6Qam, RFGW1, Netcrypt,
CaMgrDncs.
through the use of a resource model and resource
adaptor. This column contains the name of the resource
model for this edge device, e.g., GQAM, xDQA24,
TableQam, NSG8108, SEM, D6Qam, RFGW1, Netcrypt,
CaMgrDncs.
Name
The user-assigned name for the resource.
NumOutputPorts
Number of output ports on the device. This is a service
level parameter in the RFGW1 model, and is located on
the Configuration page in the GQI model.
level parameter in the RFGW1 model, and is located on
the Configuration page in the GQI model.
NumChansPerPort
Number of channels per port on the device. This
parameter is located on the Configuration page in the
GQI model.
parameter is located on the Configuration page in the
GQI model.
AlarmThreshold
The alarm threshold for an edge device. When an edge
device fails for this many consecutive attempts, the edge
device status is set to Alarm. Not applicable in the
RFGW1 model.
device fails for this many consecutive attempts, the edge
device status is set to Alarm. Not applicable in the
RFGW1 model.
FailThreshold
The failure threshold for an edge device. When an edge
device fails for this many consecutive attempts, the
resource state is set to the Failure state. Not applicable in
the RFGW1 model.
device fails for this many consecutive attempts, the
resource state is set to the Failure state. Not applicable in
the RFGW1 model.
Note: You must be service level to modify this
parameter.
parameter.
Protection
Sets protection of the device to Manual or Automatic.
When set to Automatic, a failed QAM will be protected
by a normal QAM in the same service group.
When set to Automatic, a failed QAM will be protected
by a normal QAM in the same service group.
This parameter is dependent on the
ResourceManager.Configuration.ResourceProtection
setting, and is located on the Configuration page in the
RFGW1 model.
ResourceManager.Configuration.ResourceProtection
setting, and is located on the Configuration page in the
RFGW1 model.
CtrlIpAddress
Configures/displays the IP address of the management
port of the QAM chassis.
port of the QAM chassis.
Cost
(D6QAM only)
(D6QAM only)
The cost field reported from D6.