Cisco Model 6109 6 MHz Off-Air Reference (NTSC) 安装指南
Chapter 3 USRM Web Interface
226
4039132 Rev B
Note: This example shows the page for an RFGW1.
Parameters
The following table explains the ResourceManager - QAM - Output Ports page
parameters.
parameters.
Parameter
Description
Port
The output port on the edge device.
ServiceGroupId
The identifier for the service group. When a client
registers with the server or requests a service, the client
provides the service group Id as part of the request. The
server organizes STBs by service group.
registers with the server or requests a service, the client
provides the service group Id as part of the request. The
server organizes STBs by service group.
ModulationFormat
(XDQA24 and RFGW1 only)
(XDQA24 and RFGW1 only)
The modulation format, QAM-64 or QAM-256 for the
xDQA. The RFGW1 adds Unknown and Other.
xDQA. The RFGW1 adds Unknown and Other.
AdminState
The administrative state of the port, as follows:
InService - The port is in service. The normal state.
OutOfService - The port is out of service.
Release - Selected to release all sessions on the port.
OutOfService - The port is out of service.
Release - Selected to release all sessions on the port.
OutputLevel
(RFGW1 only)
Sets/displays the output level of the carriers on the port.
Note: The valid range is dependent on the ChannelMode
setting.
setting.
ChannelMode
(RFGW1 only)
Sets/displays the number of RF carriers per output port:
None, Single, Dual, Triple, or Quad.
None, Single, Dual, Triple, or Quad.
ChannelMode2
(RFGW1 only)
When the RFGW1 is licensed for 96 channels, this
parameter sets/displays the number of RF carriers per
output port: None, Single, Dual, Triple, or Quad.
parameter sets/displays the number of RF carriers per
output port: None, Single, Dual, Triple, or Quad.
PortControl
(RFGW1 only)
Sets/displays the RF output status for the port. This
parameter is used in the SummaryStatus parameter on
the QAM Cards page.
parameter is used in the SummaryStatus parameter on
the QAM Cards page.