Cisco Model 6109 6 MHz Off-Air Reference (NTSC) 安装指南
Chapter 4 Operation
340
78-4021139-01 Rev D
Adding and Deleting Service Groups to a USRM
Using the Web Interface
Adding Service Groups to a USRM
Adding a service group and other resources to a USRM in release 1.5.0 or greater
requires a process that is a combination of procedures on the USRM as well as on the
DNCS. The basic flow of the process is as follows.
1 From the DNCS, create the service group and assign it to the USRM.
2 From the USRM, create/add/modify resources and associate service groups to
1 From the DNCS, create the service group and assign it to the USRM.
2 From the USRM, create/add/modify resources and associate service groups to
the QAM output ports.
3 From the USRM, associate zone information with the service groups for sites
configured with zones.
Note: You should open a tail of the USRM's EventLog to monitor the actions that
occur during the process.
The following sections explain each of these procedures in detail.
The following sections explain each of these procedures in detail.
Creating/Modifying a SDV-Enabled Service Group on the DNCS
Perform the following steps to create or modify a SDV-enabled service group on the
Perform the following steps to create or modify a SDV-enabled service group on the
DNCS.
1 Access the Service Group Data - Open Service Group screen.
1 Access the Service Group Data - Open Service Group screen.