Cisco DNCS System Release 2.7 3.7 4.2 安装指南
Appendix C
Configuring DTACS on an SR 7.0 System
84
OL-31613-01
Open a Remote Terminal Window on the EC and
DTACS Servers
To configure the DTACS server to run on an SR 7.0 system, you will need to add or
modify specific configurations and files on both the DTACS server and the EC. For
this reason, we recommend opening two root remote terminal windows: one that
accesses the EC server and one that accesses the DTACS server.
modify specific configurations and files on both the DTACS server and the EC. For
this reason, we recommend opening two root remote terminal windows: one that
accesses the EC server and one that accesses the DTACS server.
Important: Once this procedure is completed, we will refer to either the root remote
terminal window on the DTACS or the EC server for the remaining procedures in
this appendix.
terminal window on the DTACS or the EC server for the remaining procedures in
this appendix.
Complete the following steps to open two root remote terminal windows on each
server:
1 Open two remote terminal windows on the EC system.
2 In one remote terminal window, complete the following steps to log in as root
server:
1 Open two remote terminal windows on the EC system.
2 In one remote terminal window, complete the following steps to log in as root
user on the EC:
a Type
a Type
su –
and press Enter. You are prompted to enter your password.
b Type the root password and press Enter. The root prompt appears.
3 In the other remote terminal window, access your DTACS server by entering the
following command and pressing Enter:
ssh –X [userID]@[dtacsIP]
Notes:
Substitute your user ID that was created on your DTACS server for [userID].
Substitute the IP address for the DTACS server for [dtacsIP].
Do not include any brackets in the command.
4 In the DTACS window, type
su –
and press Enter to change to root user.
5 Enter the password when prompted.