Cisco Cisco Prisma II EDR Receiver 安装指南
Connecting the RF Cables to the Chassis
OL-32414-01
23
Connecting the RF Cables to the Chassis
To Connect RF Cables for Each Module
Complete the appropriate procedure in this section to connect RF cables for the
module.
module.
Note: This procedure assumes that the chassis is mounted in a rack.
Standard Prisma II Chassis
Note: This procedure assumes that you are using a host module with application
modules installed in both lower and upper half-slot positions. If only one module is
installed, it is not necessary to connect RF cables for the unused position.
1 Locate the RF ports on the chassis connector panel. The connector panel is on the
modules installed in both lower and upper half-slot positions. If only one module is
installed, it is not necessary to connect RF cables for the unused position.
1 Locate the RF ports on the chassis connector panel. The connector panel is on the
front of a front-access chassis, and on the rear of a rear-access chassis. The figure
below shows the connector panel for a rear-access chassis.
below shows the connector panel for a rear-access chassis.
2 Connect RF cables to the Port A and Port C connectors for the chassis slot in
which the host module will be installed. These are the RF output connections for
the module in the lower half-slot position. Hand-tighten the connectors.
the module in the lower half-slot position. Hand-tighten the connectors.
3 Route the RF cables from Ports A and C (for the lower half-slot module) to the
appropriate RF destinations.