Cisco Cisco Prisma II EDR Receiver 安装指南
2-10
Installation
78-713378-01 Rev C
Connecting Optical Cables,
Continued
Using the Fiber Fish to Pull the Optical Cable to the Prisma II Module
To get an optical cable to the module follow these procedures.
1.
Insert the Fiber Fish tool through the slot located just above the bottom of the
chassis.
2.
At the rear of the chassis, locate the appropriate optical cable.
3.
Insert the optical cable into notched area of Fiber Fish tool as shown.
4.
At the front of the chassis, pull the Fiber Fish tool (with cable attached) to the
front of the chassis.
5.
Disengage the optical cable from the Fiber Fish tool and attach to the
appropriate connector on desired module. See Cable Connection Procedure.