Cisco Cisco SG500-52PP 52-port Gigabit Max PoE+ Stackable Managed Switch 技术参考
Stack Commands
78-21491-01 Command Line Interface Reference Guide
161
8
Use the stack advanced-hybrid-xg Privileged EXEC command to perform one of
the following actions:
the following actions:
•
Change a single standalone unit to Advanced Hybrid XG mode (see User
Guidelines for an explanation of this mode).
Guidelines for an explanation of this mode).
•
Configure stack parameters, such as speeds for the units in a stack.
The new configuration takes place after reboot.
Syntax
SG500X/ESW2-550X devices): stack advanced-hybrid-xg {
1g | xg | auto
} [1 - 8 |
unit-id-auto
] [
reboot
]
SG500XG devices): stack advanced-hybrid-xg
{xg-1
—
xg-16}
{xg-1
—
xg-16}
{
1g | xg |
auto
} [1—8 |
unit-id-auto
] [
reboot
]
Parameters
Speed:
•
1g—Force stack port speed to be 1G.
•
xg—Force stack port speed to be 10G.
•
auto—Configure the stack port with the maximum speed possible on the
cable and port automatically.
cable and port automatically.
Unit Numbering: To assign unit numbers to the units in the stack, set:
•
unit
-
id
-
auto—Perform automatic numbering of units in stack.
•
1 - 8 —Unit number that can be used only if the current stack mode is
standalone or if there is only one unit in the stack. This parameter specifies
the unit ID of this unit when it becomes part of a stack.
standalone or if there is only one unit in the stack. This parameter specifies
the unit ID of this unit when it becomes part of a stack.
Note: If the user does not enter a unit ID or unit-id-auto, the unit ID of all units
are retained.
are retained.
Reboot Unit:
•
Reboot—Perform reboot on all units, after setting the new stack values on
all units.
all units.
Default Configuration
N/A