Cisco Cisco SG500-52PP 52-port Gigabit Max PoE+ Stackable Managed Switch 技术参考
Stack Commands
162
78-21491-01 Command Line Interface Reference Guide
8
Command Mode
Privileged EXEC mode
User Guidelines
This mode is used when connecting SG500X/ESW2-550X and SG500XG units in
stack. The MAC Address Table size in this case will be lowered to 16K. Both unit
types can become the stack Master
stack. The MAC Address Table size in this case will be lowered to 16K. Both unit
types can become the stack Master
In the SG500X/ESW2-550X unit, the stack ports will be s1-s2-xg.
Example
The following example sets the stack ports of an SG500XG device to be xg-1 and
xg-2 and stack ports speed to be auto in a stack unit. Reboot is performed
automatically after the command.
xg-2 and stack ports speed to be auto in a stack unit. Reboot is performed
automatically after the command.
switchxxxxxx# stack advanced-hybrid-xg xg-1 xg-2 auto reboot
8.7
stack reset
Use the stack reset Privileged EXEC command to reset either a standalone switch,
a specific unit in a stack, or all units in a stack to default factory stack parameter
values (see the User Guidelines). Note that the command also resets unit IDs to
their factory defaults.
a specific unit in a stack, or all units in a stack to default factory stack parameter
values (see the User Guidelines). Note that the command also resets unit IDs to
their factory defaults.
The new configuration takes place after reboot. If the stack mode is changed after
this operation (relevant whenever the stack mode prior to running this command is
not native mode), the startup configuration file is deleted.
this operation (relevant whenever the stack mode prior to running this command is
not native mode), the startup configuration file is deleted.
Syntax
stack reset [unit-id]
Parameters
unit-id—Unit to configure. (Range: 1–8)
Default Configuration
Operates on entire stack if unit-id is not specified.
Command Mode
Privileged EXEC mode