Asrock p4s55fx+ 用户手册

1 5

2.5 Jumpers Setup

The illustration shows how jumpers are

setup. When the jumper cap is placed on

pins, the jumper is “Short”. If no jumper cap

is placed on pins, the jumper is “Open”. The

illustration shows a 3-pin jumper whose pin1

and pin2 are “Short” when jumper cap is

placed on these 2 pins.

J u m p e r

Setting

PS2_USB_PWR1

Short pin2, pin3 to enable

(see p.7 No. 1 / p.8,  No. 1)

+5VSB (standby) for PS/2

or USB wake up events.

Note: To select +5VSB, it requires 2 Amp and higher standby current provided

by power supply.

JR1/JL1 Jumpers

(see  p.7 No. 25 / p.8 No. 23)

Note: If the jumpers JL1 and JR1 are short, both the front panel and the rear panel

audio connectors can work.

Clear CMOS

(CLRCMOS1, 2 solder points)

(see p.7 No. 15 / p.8 No. 13)

Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes

system setup information such as system password, date, time, and system

setup parameters. To clear and reset the system parameters to default setup,

please turn off the computer and unplug the power cord, then short the solder

points for more than 3 seconds by using metal material, e.g., a paper clip. If you

need to clear the CMOS when you just finish updating the BIOS, you must boot

up the system first, and then shut it down before you do the clear-CMOS

action.

Short

Open

JR1

JL1

solder points