Asrock p4s55fx+ 用户手册

1 6

2.6 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place jumper

caps over these headers and connectors. Placing jumper caps over the

headers and connectors will cause permanent damage of the motherboard!

FDD Connector

(33-pin FLOPPY1)

(see p.7 No. 19 / p.8 No. 17)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE Connector (Blue)

Secondary IDE Connector (Black)

(39-pin IDE1, see p.7 No. 9 / p.8,  No. 9)

(39-pin IDE2, see p.7 No. 8 / p.8,  No. 8)

Note: If you use only one IDE device on this motherboard, please set the IDE

device as “Master”. Please refer to the instruction of your IDE device vendor

for the details. Besides, to optimize compatibility and performance, please

connect your hard disk drive to the primary IDE connector (IDE1, blue) and

CD-ROM to the secondary IDE connector (IDE2, black).

Serial ATA  Connectors

Serial ATA (SATA)  connectors

(Only on P4S55FX+ motherboard)

are only available on P4S55FX+

(SATA2: see p.7 No. 13)

motherboard. These two Serial

(SATA1: see p.7 No. 14)

ATA (SATA) connectors support

SATA data cables for internal

storage devices. The current

SATA interface allows up to

1.5 Gb/s data transfer rate.

Serial ATA (SATA)

Either end of the SATA data cable

Data Cable

can be  connected to the SATA

(Only for P4S55FX+ motherboard)

hard disk or the SATA connector

on the motherboard.

FLOPPY1

Pin1

IDE1

PIN1

IDE2

PIN1

connect  the black end

to the IDE devices

connect the blue end

to the motherboard

80-conductor ATA 66/100/133 cable

the red-striped side to Pin1

SATA2

SATA1