3com WX2200 3CRWX220095A 用户手册

C

HAPTER

 5: C

ONFIGURING

 

AND

 M

ANAGING

 P

ORTS

 

AND

 VLAN

S

All WX switch ports are network ports by default. You must set the port 
type for ports directly connected to MAP access ports and to wired user 
stations that must be authenticated to access the network. When you 
change port type, MSS applies default settings appropriate for the port 
type. Table 5 lists the default settings applied for each port type. For 
example, the MAP column lists default settings that MSS applies when 
you change a port type to ap (MAP). 

Table 6 lists how many MAPs you can configure on a WX switch, and 
how many MAPs a switch can boot. The numbers are for directly 
connected and Distributed MAPs combined. 

Table 5   Port Defaults Set by Port Type Change

VLAN 
membership

Removed from 
all VLANs. You 
cannot assign a 
MAP access port 
to a VLAN. MSS 
automatically 
assigns MAP 
access ports to 
VLANs based on 
user traffic.

Removed from all VLANs. 
You cannot assign a 
wired authentication port 
to a VLAN. MSS 
automatically assigns 
wired authentication 
ports to VLANs based on 
user traffic.

None

Note: If you clear a 
port, MSS resets the 
port as a network 
port but does not 
add the port back to 
any VLANs. You 
must explicitly add 
the port to the 
desired VLAN(s).

Spanning Tree 
Protocol (STP)

Not applicable

Not applicable

Based on the STP 
states of the VLANs 
the port is in.

802.1X

Uses 
authentication 
parameters 
configured for 
users.

Uses authentication 
parameters configured for 
users.

No authentication.

Port groups

Not applicable

Not applicable

None

IGMP snooping Enabled as users 

are 
authenticated 
and join VLANs.

Enabled as users are 
authenticated and join 
VLANs.

Enabled as the port 
is added to VLANs.

Maximum user 
sessions

Not applicable

1 (one)

Not applicable