Sony sdx-d400c

12

Part 2.  Preparation

The SCSI ID is set by the rotary switch on the rear panel. Press the + or -
buttons to move the number up or down, respectively.
As shipped from the factory, the SCSI ID is set to 0. Press the switch buttons,
if necessary, to select the SCSI ID number you require.

Precautions
• The SCSI ID must be different from IDs of the other peripherals on the

SCSI bus.

• As shipped from the factory, Term power is ON.  A SCSI bus terminator

• Before changing the SCSI ID setting, be sure to turn off the power with the

POWER switch on the front panel.

Remove the two slotted screws by using a slotted screwdriver.  Remove the
access cover to change the DIP switch settings.  (Refer to the following
figure for details changing the DIP switch settings.)
After changing the DIP switch settings, replace access cover and tighten the
two slotted screws using a slotted screwdriver.

CAUTION
Before removing the access cover to change DIP switch settings on the
drive, turn off the computer and disconnect the power cord from the unit.
Once the DIP switch settings have been changed, replace the access cover
using the two original slotted screws provided.

Figure 2-2.  DIP Switch Access

Access Cover

DIP Switch

Slotted
Screws