Panasonic sa-ht1000 用户手册

RQT7061

≥The program was copy-guarded. 
≥No space left on the disc.

➡Create space by erasing any unwanted programs. [RAM]

➡Use a new disc. [RAM] [DVD-R]

≥Recording was not completed for some other reason.

≥The disc is scratched. Use another disc.
≥The disc is dirty.
≥You inserted an incompatible disc.

≥The program is write-protected. Cancel the protection.
≥The disc is write-protected. Cancel Disc Protection.

≥No space left on the disc.

➡Create space by erasing any unwanted programs. [RAM]

➡Use a new disc. [RAM] [DVD-R]

≥A serious, but temporary error has occurred and one of the unit’s safety devices has 

activated. Press [ENTER]. The unit switches to the standby mode. Press [

Í POWER] to 

turn the unit on again.

≥To enable playback of your DVD-R on compatible equipment, it is necessary to finalize it.

≥You haven’t inserted a disc. Correctly insert a disc that this unit can use. 
≥The disc is upside down. If it is a single-sided disc, insert it so the label is facing up. 

≥The write-protect tab on the cartridge is set to PROTECT.

Use a ballpoint pen or similar to release the write protection.

≥The clock is not set.

≥You inserted an incompatible disc.

≥You tried to play a disc with a region number different from this unit’s region number. This 

unit can only play discs with the region numbers compatible with this unit (1, All, or 
including the number 1). 

≥The unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized DVD-R. 
≥You inserted an unformatted DVD-RAM. Format the disc with this unit.

≥A ratings level has been set for DVD-Video with this unit. Unlock the unit with “Ratings” in 

“Disc”.

 CHK REMOTE

(“

∑” stands for a number.)

≥The remote control and main unit are using different codes. Change the code on the 

remote control. 

≥Check and correct the speaker cord connections.

If this does not fix the problem, there is a power supply problem. Consult the dealer.

≥There is no signal input to the L1 OPTICAL IN terminal.

➡Make sure to check the connections and if the power of the connected equipment is 

turned on.

≥The disc is dirty or badly scratched.

➡Clean the disc if it is dirty. 

➡The disc cannot be played if it is scratched and this display doesn’t disappear.

≥The unit cannot read the disc.
≥You have used a DVD-RAM/PD lens cleaner and it has finished.

≥There was a power failure or the AC plug was disconnected while the power was on. The 

unit is carrying out its recovery process. Wait until the message disappears. 

≥The unit is hot.

➡The unit switches to standby automatically for safety reasons and you cannot operate it. 

Wait for about 30 minutes for the service number to disappear.

➡Select a position with good ventilation when installing the unit.

➡Do not block the cooling fan on the rear of the unit.

≥The unit fails to operate properly. Press [Í POWER] to switch the unit to standby. Now 

press [

Í POWER] again to turn the unit on.

≥You have inserted a disc the unit cannot play or record on.
≥The signal input into the L1 OPTICAL IN terminal is not Dolby Digital or Linear PCM.

7061en.book  47 ページ  ２００３年７月１日　火曜日　午前１１時４４分