Crestron cen-tvav 用户手册
Ethernet Enabled Programmable TV/AV Controller
Crestron CEN-TVAV
CAUTION: If making connections to the Cresnet peripherals from the CRESNET
port, refer to “Cresnet Modular Cabling” on page 8.
port, refer to “Cresnet Modular Cabling” on page 8.
NOTE: Refer to the latest revision of the STIRP Installation Instructions (Doc.
5674) for details to attach the STIRP near the IR sensor window of the TV or AV
device. This document can be obtained from the Downloads page (MANUAL
Library) of Crestron’s website (www.crestron.com). Search for STIRP.PDF.
5674) for details to attach the STIRP near the IR sensor window of the TV or AV
device. This document can be obtained from the Downloads page (MANUAL
Library) of Crestron’s website (www.crestron.com). Search for STIRP.PDF.
NOTE: The power plug is used to connect or disconnect power from the unit. Other
than making the power connection last, complete the connections in any order.
than making the power connection last, complete the connections in any order.
NOTE: An optional handheld IR transmitter must have an unobstructed line-of-
sight to the IR receiver of the CEN-TVAV. Make sure nothing is between the
transmitter and the CEN-TVAV that would prevent maximum signal reception.
sight to the IR receiver of the CEN-TVAV. Make sure nothing is between the
transmitter and the CEN-TVAV that would prevent maximum signal reception.
Typical Connections for Normal Operation
CRESNET
ETHERNET
RS-232
IR
6.6A MAX
50-60HZ
115 VAC
POWER OUT 6A MAX
POWER IN
CRESTRON ELECTRONICS INC. ROCKLEIGH, N.J. 07647 USA
I/O
1 2 3 4 G
TO LAN/WAN
VIA HUB
TO STIRP OR
OTHER IR DEVICE
TO VAC
OUTLET
TO CRESNET
PERIPHERALS
TO TV OR
AV DEVICE
TO OTHER
PERIPHERALS
Loading Crestron Control Software
Crestron control software is available in an electronic form; CD-ROM, email, or
from Crestron’s website. Regardless of how and from where the software is
obtained, this section provides the necessary installation steps. Before performing the
procedures in this section, refer to “Cable Configuration for Programming” on
page 8 for cabling instructions.
from Crestron’s website. Regardless of how and from where the software is
obtained, this section provides the necessary installation steps. Before performing the
procedures in this section, refer to “Cable Configuration for Programming” on
page 8 for cabling instructions.
Installing Crestron Development Tools
Crestron provides software tools for programming the CEN-TVAV. Even if only the
control software is being loaded into the hardware and there are no plans to do any
programming, some Crestron development software must be installed on the PC.
Currently, Crestron programming is accomplished with the use of the following
development tools listed in the table shown on the next page.
control software is being loaded into the hardware and there are no plans to do any
programming, some Crestron development software must be installed on the PC.
Currently, Crestron programming is accomplished with the use of the following
development tools listed in the table shown on the next page.
NOTE: If the intent is to load software developed elsewhere, install SIMPL
Windows only. To program control systems, install all three applications.
Windows only. To program control systems, install all three applications.
12
• Ethernet Enabled Programmable TV/AV Controller: CEN-TVAV
Operations Guide - DOC. 5720A