TP-LINK TD-8816 用户手册

 

38 

he rule. 

the rule. 

iority via DHCP (the header of IP group). It maps 

ure the action that the modem router takes to deal with the traffic which accord 

the DSCP priority. 

 

Queue #: Select the priority type for the action. 

ment, bandwidth allocation and resource 

ical switch port is configured with an access list specifying 

d 

deliver them to their destination by converting an Ethernet MAC address into an ATM address. 

will take the corresponding action to deal with it. 
 

Rule Index: Select the index for the rule you want to configure. 

 

Active: Activate the rule. The rule can take effect only when it is activated. 

 

Destination IPv6: Enter the IP information about the Destination host for t

 

Source IPv6: Enter the IP information about the Source host for 

 

DSCP Range: Enter the DSCP range to differentiate the traffic. 

When you select DSCP, you can assign the pr

the IP group into corresponding service class. 



  Action: Config

with the rule. 
 

DSCP Remarking: Enter the number to remark 

Choose “Advanced Setup→VLAN”, you can activate the VLAN function in the next screen. 

Virtual LAN (VLAN) is a group of devices on one or more LANs that are configured so that they 
can communicate as if they were attached to the same wire, when in fact they are located on a 
number of different LAN segments. Because VLANs are based on logical instead of physical 
connections, it is very flexible for user/host manage
optimization. There are two types of VLAN as follows: 

Port-Based VLAN: Each phys
membership in a set of VLANs. 
ATM VLAN: Using LAN Emulation (LANE) protocol to map Ethernet packets into ATM cells an

 

Figure 4-29 

N Group in Figure 4-29, you can define VLAN groups in the next screen (shown 

in Figure 4-30).