Allied Telesis AT-TQ2403 用户手册

AT-TQ2403 Management Software User's Guide 

97 

  If you are operating in an 802.11h enabled domain, then the channel selection of the BSS will always 

be "Auto". Even if another channel has been has been configured, this will be ignored and auto- 

channel selection will occur. 

  When 802.11h is enabled, the initial boot-up time will increase by a minimum of sixty seconds. This 

is the minimum time required to scan the selected channel for radar interference. 

  Setting up WDS links may be difficult when 802.11h is operational. This is because the operating 

channels of the two APs on the WDS link may keep changing depending on channel usage and radar 
interference. WDS will only work if both the APs operate on the same channel. For more 

information on WDS, see “

”. 

The radio interface allows you to set the radio Channel and 802.11 mode as described below. 

 



Note: You must configure these radio interface settings for both Radio Interface One 

and Radio Interface Two. 

 

Indicates the Media Access Control (MAC) addresses for the interface. 

The MAC addresses for Radio Interface One (Internal/Guest) and Radio Interface 
Two (Internal/Guest) are shown. 

A MAC address is a permanent, unique hardware address for any device that 

represents an interface to the network. The MAC address is assigned by the 

manufacturer. You cannot change the MAC address. It is provided here for 

informational purposes as a unique identifier for an interface. 

The Mode defines the Physical Layer (PHY) standard being used by the radio.

 

The AT-TQ2403 is dual band access point with two radios. Select one of these modes: 

a mode for each Radio Interface. 

For Radio Interface 1 

  IEEE 802.11a 

  Atheros Turbo 5G GHz 

  Atheros Dynamic Turbo 5G GHz 

For Radio Interface 2 

  IEEE 802.11b 

  IEEE 802.11g 

  Atheros Turbo 2.4 GHz 

  Atheros Dynamic Turbo 2.4 GHz 

Select an IEEE 802.11 mode for each of the two radio interfaces.  

Note: The turbo function depends on Country Domain and Product model. Not all 
country and model support the turbo function.