Allied Telesis AT-TQ2403 用户手册

98 

AT-TQ2403 - Management Software - User's Guide 

Select the Channel. The range of channels and the default is determined by the Mode 

of the radio interface. 

The Channel defines the portion of the radio spectrum the radio uses for transmitting 

and receiving. Each mode offers a number of channels, dependent on how the 
spectrum is licensed by national and trans-national authorities such as the Federal 

Communications Commission (FCC) or the International Telecommunication Union 

(ITU-R). 

If you select a number from the list as the operating channel, due to DFS function (See 

“

”), the actual operating channel might be 

different from your selection. 

If you want to know the current operation channel, please reference to chapter 10 

 (status -> Interface), the value of channel of Wireless 

Settings.  

This item is the settings about Link Relay.  

The Link Relay is a feature which automatically disables the wireless interface when 
the link of LAN interfaces is down.  

  To enable Link Relay, click Enabled.  

  To disable Link Relay, click Disabled.  

Note: This function is not operated when WDS bridge is configured. 

 

The Internal Settings describe the MAC Address (read-only) and Network Name (also known as the 
SSID) for the internal Wireless LAN (WLAN) as described below. 

Field 

Description 

Shows the MAC address(es) for Internal interface for this access point. 
This is a read- only field that you cannot change. 

Although this access is point is physically a single device, it can be 

represented on the network as two or more nodes each with a unique 

MAC Address. This is accomplished by using multiple Basic Service Set 

Identifiers (BSSIDs) for a single access point. 

The MAC address(es) shown for the "Internal" access point is the 
BSSID(s) for the "Internal" interface. 

Two MAC addresses are shown: one for each Radio on the Internal 

interface.