Autostart as-1452 hf 用户手册

User Guide 

P. 5 

If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds 

and try to start the engine again. 

If your vehicle is equipped with an automatic transmission

, 

there will be 3 start attempts before the system gives up. 

Driving Off 

With the vehicle running under remote control, press the 

 button to 

 and 

 

the doors (if installed). Enter the vehicle and do the following: 

•  Turn the ignition key to the 

 position. 

•  Press the brakes to disengage the remote starter unit. 

You are now ready to drive off. 

Caution: do not turn the key to the 

 position with the engine running. This will cause 

the starter motor to re-engage, unless your vehicle is equipped with the Start Kill / Anti-

Grind Feature (Optional). 

Remote starter features 

Idle Mode 

Convenience feature: Idle Mode allows you to keep the engine running and the doors 

locked while you stop, for example, at a convenience store or for a short delivery. 

This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in 

the Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a 

convenience store, lock your vehicle and leave it running for the length of a run cycle while 

you are away. 

To leave the vehicle in Idle Mode if your vehicle has an automatic transmission: 
1.  With the engine running, press the 

 or 

 button (to unlock the doors) or 

the 

 button on the remote control until the parking lights come on. 

2.  Remove the key and exit the vehicle. The engine will go on running. 
3.  Lock the doors if needed. 

The engine will go on running until the user re-enters the vehicle or until the expiration of the 

Engine Run Time. 

 

If your vehicle has a manual transmission, Idle Mode can be activated through the same 

routine as that used for Ready Mode; at the last step, the 

 button is pressed instead of 

the other buttons: 

4.  Ensure that the doors are all closed and that the gearshift lever is in the Neutral 

position. 

5.  With the engine already running, apply the parking brake and release the brake 

pedal. 

•  Make sure to release the brake pedal. 

6.  Within 20 sec. push 

, 

 or 

 on the transmitter. 

•  The parking lights will flash 3 times quickly and remain lit. 

7.  Remove the key: the engine will go on running. 
8.  Exit the vehicle and close the door. 
9. Press 

the 

 button until the system is armed (the doors will be locked if remote 

door lock is installed). 

If the pre-programmed run-time expires or if the user shuts down the engine by remote 

control, the vehicle will get in Ready Mode. 

Caution: Do not leave children or pets unattended in a car running in Idle Mode.