Motorola 7.7.4 用户手册

190

then enter the configuration values appropriate for your site without having to enter com-
plete CLI commands.

When you are in step mode, the command line inter face prompts you to enter required and 
optional settings. If a setting has a default value or a current setting, the command line 
inter face displays the default value for the command in parentheses. If a command has a 
limited number of acceptable values, those values are presented in brackets, with each 
value separated by a ver tical line. For example, the following CLI step command indicates 
that the default value is 

 and that valid entries are limited to 

 and 

.

option (off) [on | off]: 

on

You can accept the default value for a field by pressing the Return key. To use a different 
value, enter it and press Return.

You can enter the CONFIG step mode by entering 

 from the top node of the CONFIG hier-

archy. You can enter step mode for a par ticular ser vice by entering 

 

In stepping set mode (press Control-X <Return/Enter> to exit. For example:

Netopia-3000/9437188 (top)>> 

...
system
   name (“Netopia-3000/9437188”): 

   Diagnostic Level (High): 

Stepping mode ended.

You can use the 

 CONFIG command to make sure that your configuration set-

tings have been entered correctly. If you use the 

 command, the Motorola 

Netopia® Gateway verifies that all required settings for all ser vices are present and that 
settings are consistent.

Netopia-3000/9437188 (top)>> 

Error: Subnet mask is incorrect
Global Validation did not pass inspection!

You can use the 

 command to verify your configuration settings at any time. 

Your Motorola Netopia® Gateway automatically validates your configuration any time you 
save a modified configuration.