Motorola surfboard svg2501u 用户手册

B 

 

 
Cabling the Gateway • Installing the Battery 

SVG2501 Series Wireless Voice Gateway • User Guide 

550885-001-a  
 

 

 

• 

This product is for indoor use only. Do not route the telephone lines, USB 

and/or Ethernet cable(s) outside of the building. Exposure of the cables to 
lightning could create a safety hazard and damage the product. 

• 

Before starting the battery installation, see 

 for 

information. 

• 

The battery is not intended for everyday use, only for power backup during a 

power outage. 

• 

Install the battery before installing any other gateway components.  

1.  To remove the battery cover located on the bottom of the gateway, place the 

gateway on its side with the LEDs facing up, press down on the upper two locking 
tabs and then pull open the cover. 

2.  Line up the battery terminals and then slide the battery into the compartment until it 

locks in place. 

 

 

 

 

 

3.  Set the battery cover into the bottom of the gateway and press down on the upper 

two locking tabs, and then push the cover shut until the tabs snap into place.