Motorola surfboard svg2501u 用户手册

B 

 

 
Cabling the Gateway • Connecting the SVG2501 

SVG2501 Series Wireless Voice Gateway • User Guide 

550885-001-a  
 

 

• 

To reduce the risk of fire, use only No. 26 or larger UL Listed or CSA Certified 

Telecommunication Line Cord or national equivalent to connect a telephone 
line to your SVG2501. 

• 

Contact your cable service provider before connecting your Motorola 

wireless voice gateway to existing telephone wiring. DO NOT connect the 
telephone cable from the TEL port to a traditional telephone (PSTN) service; 
only connect it to a telephone.  

1.  Connect the coaxial cable to a grounded cable TV outlet or splitter. 

2.  Connect the other end of the coaxial cable to the Cable connector on the gateway. 

Hand-tighten the connectors to avoid damaging them. 

3.  Plug the power cord into the Power port on the gateway. 

4.  Plug the other end of the power cord into an electrical wall outlet.  

This powers on the gateway. Allow the gateway 5- to 30 minutes to find and lock on 
the appropriate communications channels. 

5.  Connect the Ethernet cable to the Ethernet port on your computer. 

6.  Connect the other end of the Ethernet cable to an Ethernet port on the gateway. 

Repeat steps 5 and 6 for each additional computer. 

7.  Plug the telephone cord of a single- or two-line telephone into the telephone. 

8.  Plug the other end of the telephone cord into the TEL 1/2 port on the gateway. 

Use the TEL 1/2 port to connect two-line telephones. 

Note: Contact a VoIP service provider to activate this service.  

9.  For a second telephone, plug the telephone cord of a single-line telephone into the 

TEL 2 port on the gateway.