Chevrolet 2010 impala 用户手册

下载
页码 420
A. Windshield Washer Fluid Reservoir. See “Adding
B. Battery. See Battery on page 6‑38.
C. Underhood Fuse Block. See Underhood Fuse
D. Remote Positive (+) Terminal. See Jump Starting
E. Coolant Recovery Tank. See “Checking Coolant”
F. Pressure Cap. See Cooling System on page 6‑24.
G. Power Steering Fluid Cap. See Power Steering
H. Engine Oil Fill Cap. See “When to Add Engine Oil”
I. Engine Oil Dipstick. See “Checking Engine Oil”
J. Automatic Transmission Fluid Dipstick (Out of
View). See “Checking the Fluid Level” under
Automatic Transmission Fluid on page 6‑21.
K. Brake Master Cylinder Reservoir. See “Brake
Fluid” under Brakes on page 6‑35.
L. Engine Air Cleaner/Filter. See Engine Air
Engine Oil
Checking Engine Oil
It is a good idea to check the engine oil level at each
fuel fill. In order to get an accurate reading, the oil must
be warm and the vehicle must be on level ground.
The engine oil dipstick handle is a yellow loop.
See Engine Compartment Overview on page 6‑14
for the location of the engine oil dipstick.
1. Turn off the engine and give the oil several minutes
to drain back into the oil pan. If this is not done, the
oil dipstick might not show the actual level.
2. Pull out the dipstick and clean it with a paper towel
or cloth, then push it back in all the way. Remove it
again, keeping the tip down, and check the level.
6-15