Q-Logic 8200 用户手册
2–Configuring NIC
NIC TroubleShooting/Diagnostics
SN0054671-00 A
2-53
Windows Diagnostic Test Messages
If a test fails, an appropriate error code is generated and displayed, as shown in
. Note that this table does not list error messages for the interrupt and
link tests.
Table 2-9. Windows Diagnostic Test Messages
Test
Error Message
Description
Loopback
LB_TEST_OK
Loopback test has passed
LB_SEND_WAIT_QUEUE_E
RR
RR
Send queue blocked
LB_NORCV_ERR
Receive packet not received
LB_NOMEM_ERR No
memory
error
LB_TX_QUEUE_ERR
Transmit queue error
LB_SHORT_DATA_ERR
Looped data short error
LB_SEQUENCE_ERR
Looped data out of sequence
LB_DATA_ERR
Looped data corrupted
LB_ERR_CNT
Looped error count
Register
CR_TEST_OK
Control register test passed
CR_NIU_MODE
Network interface unit (NIU) error
CR_PHY
Physical layer (PHY) error
CR_ERRCNT
Control register error count
Hardware
HW_TEST_OK
Hardware test has passed
HW_DMA_BZ_0
DMA channel 0 is busy
HW_DMA_BZ_1
DMA channel 1 is busy
HW_DMA_BZ_2
DMA channel 2 is busy
HW_DMA_BZ_3
DMA channel 3 is busy