Hitachi travelstar hds723020bla642 用户手册
7K200 SATA OEM Specification
41/
173
7.3 Signal definitions
The pin assignments of interface signals are listed as follows:
No.
Plug Connector pin definition
Signal
I/O
S1 GND
2nd
mate
Gnd
S2
A+
Differential signal A from Phy
RX+
Input
S3 A-
RX- Input
Signal S4 Gnd
2nd
mate
Gnd
S5
B-
Differential signal B from Phy
TX-
Output
S6 B+
TX+ Output
S7 Gnd
2nd
mate
Gnd
Key and spacing separate signal and power
segments
segments
P1 V33
3.3V
power
3.3V
P2 V33
3.3V
power
3.3V
P3
V33
3.3V power, pre-charge, 2nd Mate
3.3V
P4 Gnd
1st
mate
Gnd
P5 Gnd
2nd
mate
Gnd
P6 Gnd
2nd
mate
Gnd
P7
V5
5V power,pre-charge,2nd Mate
5V
P8 V5
5V
power
5V
Power P9 V5
5V
power
5V
P10 Gnd
2nd
mate
Gnd
P11
DAS/DSS
Device Activity Signal / Disable Staggered
Spinup
Spinup
1
Note 1
P12 Gnd
1st
mate
Gnd
P13
V12
12V power,pre-chage,2nd mate
V12
P14 V12
12V
power
V12
P15 V12
12V
power
V12
Table 23. Interface connector pins and I/O signals
Note 1;
Pin P11 is used by the drive to provide the host with an activity indication and by the host to
indicate whether staggered spinup should be used.
The signal the drive provides for activity indication is a low-voltage low-current driver.
If pin P11 is asserted low the drive shall disable staggered spin-up and immediately initiate
spin-up. If pin P11 is not connected in the host (floating), the drive shall enable staggered spin-up.
Pin P11 is used by the drive to provide the host with an activity indication and by the host to
indicate whether staggered spinup should be used.
The signal the drive provides for activity indication is a low-voltage low-current driver.
If pin P11 is asserted low the drive shall disable staggered spin-up and immediately initiate
spin-up. If pin P11 is not connected in the host (floating), the drive shall enable staggered spin-up.
7.3.1
TX+ / TX-
These signal are the outbound high-speed differential signals that are connected to the serial ATA
cable
cable
7.3.2
RX+ / RX-
These signals are the inbound high-speed differential signals that are connected to the serial ATA
cable.
The following standard shall be referenced about signal specifications.
cable.
The following standard shall be referenced about signal specifications.
Serial ATA International Organization: Serial ATA Revision 2.6 15-February -2007