Korg triton-rack 信息指南

To prevent programs, combinations, multis, drum kits 
and user arpeggio patterns from being overwritten 
accidentally, the TRITON-Rack provides a Memory 
Protect setting that prohibits writing to memory.

Before you save edited data or load data from floppy 
disk or other external media, use the following proce-
dure to turn off memory protect (uncheck the appropri-
ate check box).

You should also turn memory protect off if you want to 
load the above data from external media or via MIDI 
data dump, or if you wish to record or edit patterns in 
Multi mode.

1 Press the [GLOBAL] key to enter Global mode 

2 Press the [F2] (“Pref.”) key to access the 1.1: Sys-

3 Uncheck the appropriate “Memory Protect” check 

The programs or combinations that you create by using 
the Performance Editor or by editing parameters in the 
various edit (Ed) pages can be saved in the internal 
memory of the TRITON-Rack. This action is referred to 
as “writing a program” or “writing a combination.” If 
you want your edited data to be preserved after the 
power is turned off, you must write it.

There are two ways to write a program or combination.

Before you write data into memory, you must turn 
off the memory protect setting in Global mode.
(

☞

1 Select the Utility “Write Program” or “Write Com-

The Write Program/Write Combination dialog box 
will appear.

You can also access the same dialog box by holding 
down the [ENTER] key and pressing the [0] key.

The screen shown is for Program mode

2 In “Category,” specify the category of the program/

If the category you specify here is for a program, 
you can use it when selecting by category in the Cat. 
Hold function or the “Select by Category” utility in 
PROG 1.1: Play, “Program Select” in the COMBI 1.1: 
Play, Prog page, the COMBI 2.1: Ed-Prog/Mix.Prog 
page, or the MULTI 1.1: Play, Program page utility 
“Select by Category.”

In the case of a Combination, the category you spec-
ify here can be selected when you use the “Select by 
Category” utility or the Cat. Hold function in 
COMBI 1.1: Play: (“Combi Select”).

3 Use “To” to specify the bank and number of the 

Use the [VALUE] dial, [BANK], [A]–[H], [INC], 
[DEC] keys, or numeric keys [0]–[9] and the 
[ENTER] key to specify the destination.

4 If you wish to change the name of the program/

The text dialog box will appear. Input the name of 
the program/combination. 

☞

5 To execute the Write operation, press the [F8] 

When you press the [F8] (“OK”) key, the display 
will ask “Are you sure?” When you press the [F8] 
(“OK”) key once again, the data will be written.

This method can only be used to write to the selected 
program/combination number.

1 Press the [WRITE] key.

The following dialog box will appear.

The screen shown is for Program mode

2 To write the data, press the [F8] (“OK”) key. To