Korg triton-rack 信息指南

Editing a multisample is accomplished with a number 
of operations i.e. creating indexes for the multisample 
and assigning a sample to each index, editing opera-
tions such as deleting, copying, and inserting indexes, 
and detailed settings such as sample level and pitch for 
each index.
Multisample editing is performed in 4.1: Multisample.

Basic settings such as creating indexes and assign-
ing samples can also be made in the 1.1: Recording, 
Sample page.

To change the number or order of the indexes, use the 
Insert

, Cut, Copy, and Create.

1 Select 4.1: Multisample.

2 Use “MS (Multisample Select)” to select the multi-

3 Select the “Index.”

You can also select this by holding down the 
[ENTER] key and playing a note on a connected 
MIDI instrument.

4 Press the keys corresponding to the following 

To delete the selected index, press the “Cut.” 
The “Insert” is used in conjunction with the Cut and 
“Copy.” The contents of the index that was Cut or 
Copied will be inserted.
The “Create” has the same function as the “Create” 
in 1.1 Recording, Sample (☞p.70 “Creating multi-
sample indexes and sampling”).

1 Make the settings described in steps 1–3 of 

2 Set parameters for the selected index.

(

☞

• Changing the Edit1 page “Top K (Top Key)” will 

change the upper limit of the zone. Simultaneously, 
the lower limit of the next-numbered index will 
also change.

• If you check “Constant Pitch” in the Edit2 page, 

playing any note on a connected MIDI instrument 
within the zone of an index will always sound the 
original pitch.

• Edit2 page “Pitch” adjusts the sample pitch for 

each index. You can use the Utility “Pitch BPM 

Adj.” to set the loop interval to a desired BPM 
value (

PG p.102).

The “Conv. To Prog” utility can be selected and exe-
cuted in the various pages of 1.1: Recording, in 2.1: 
Sample Edit, in Edit 1 of 3.1: Loop Edit, in the various 
pages of 4.1: Multisample, and in 5.2: Ctrl Setup. When 
you execute this utility, the state of the currently 
selected multisample will be converted into a program.
In Program mode you can make filter, amp and effect 
settings etc., and play the sample as a program. The 
resulting program can be used in a combination or 
multi.

For details on using the “Conv. To Prog” utility, refer to 
p.32 and PG p.83.

A sample you created in Sampling mode can be used as 
one of the instruments in a drum kit. In the GLOBAL 
5.1: DKit, High Sample page and Low Sample page, set 
“Drumsample Bank” to RAM, and use “Drumsample” 
to select the sample that you created.