Konica Minolta kn-304 用户手册

2-4  KN-304  Network Board

Chapter 2  Setting up from the LCD Panel

You can change the password by selecting [3. Password Protection].  You can also disable the

password so that no password be used.  No password is defined by default.

On completion of setup, turn off the main power of the Konica 7020 series and wait for about

6 seconds.  Then turn on power again, and the settings you have entered are effective.

(It may take 2-3 minutes after power-on until the KN-304 is ready to work.)

■

 TCP/IP setup

TCP/IP must be set up to print peer-to-peer by Windows 95/98 or to print by lpd/lpr of Windows NT.

You select [1. TCP/IP Setup] from the [Network Setup] menu, and the [TCP/IP Setup] menu appears as

shown below.  Press the number key associated with the desired menu item.  Press [Previous] to go back

to the previous menu.

1. Set IP mode

You select the mode of assigning the IP address, dynamic by DHCP (Dynamic Host Configu-

ration Protocol) or static (manual).

2. IP Settings

You set up when the static mode of assigning the IP address is selected.  You cannot select

this option if “Enable DHCP” is selected.

3. LPD Banner Enable

To print by lpd/lpr, you designate whether to use LPD banner or not.  The LPD banner is a

piece of information on printout made by lpd/lpr, printed on a banner page.  LPD banner is not

used by default.