Konica Minolta 7013 psc 用户手册

 

Hardware Installation-1

 

2

 

Installing the Print Server Card

 

If the printer can generate a test or status page, you should generate one before you 
begin. This will give you detailed information on the identification and configuration 
of your printer, as well as ensuring that the printer is properly set up and operating.

If you are installing an Ethernet Print Server Card, continue to step 1. If you're install-
ing a Token Ring board, you must first set the speed to the same setting as the Token 
Ring adapter cards on your network. Refer to 

 

 for details.

 

Warning:

If you are installing a Token Ring card, you must set the network speed now. 

Changes made after start-up or after you power up the Print Server Card will 

not be implemented and may cause problems. If you do not set the speed to 

match the speed of other Token Ring adapter cards on the network, all traffic 

 

on the network will come to a halt.

1. Make sure that the printer is operating properly. Check to see that paper is in the 

paper tray and toner cartridge is full. If the printer handles multiple printer lan-
guages, make sure it is set up for automatic emulation sensing or PCL or ASCII 
mode.

2. Turn off the printer and remove the power cord.

3. Install the Print Server Card in the option port, according to the printer manufac-

turer instructions.  

 

Note:

 

The Print Server Card is 

designed to protect sensitive components from damage due to electrostatic dis-

charge (ESD) during normal operation. When performing installation procedures, 

 

however, take proper static control precautions to prevent damage to equipment.