Konica Minolta 7013 psc 用户手册

 

Hardware Installation-2

 

This section is for Token Ring installations only. Go to Section 2.3 if you are installing 
the Ethernet Print Server card. 

The Token Ring speed is selected by the position of jumper 12 (JP12) on the Print 
Server Card. The factory 

 

for the jumper is across pins 2-3, selecting 

 

. If this is the speed that your network uses, then you do not need to do any-

thing. If you need to change the speed to 4Mbps, you must reposition the jumper 
across pins 1-2. Follow the instructions below:
1. Make sure you remove the power cord from the printer.
2. Locate Jumper JP12 on the Print Server Card.

3. Once you locate Jumper JP12, move the jumper to between pins 1-2. This changes 

the speed setting to 4Mbps.

4. Install the Print Server Card in the option port, according to the printer manufac-

turer instructions.  

 

Note:

 

The Print Server Card is 

designed to protect sensitive components from damage due to electrostatic dis-

charge (ESD) during normal operation. When performing installation procedures, 

 

however, take proper static control precautions to prevent damage to equipment.