National Instruments pci-6110e-6111e 用户手册

 National Instruments Corporation

2-1

This chapter explains how to install and configure your 611X E board.

Install your software before you install the 611X E board. Refer to the 
appropriate release notes indicated below for specific instructions on 
the software installation sequence.

If you are using LabVIEW, LabWindows/CVI, or other National 
Instruments application software packages, refer to the appropriate 
release notes. After you have installed your application software, refer 
to your NI-DAQ release notes and follow the instructions given there 
for your operating system and application software package.

If you are using NI-DAQ, refer to your NI-DAQ release notes. Find 
the installation section for your operating system and follow the 
instructions given there.

You can install the 611X E board in any available expansion slot in your 
computer. However, to achieve best noise performance, leave as much 
room as possible between the 611X E board and other boards and 
hardware. The following are general installation instructions, but 
consult your computer user manual or technical reference manual for 
specific instructions and warnings.

1. Write down the 611X E board serial number in the

 

 of this manual.

2. Turn off and unplug your computer. 

3. Remove the top cover or access port to the I/O channel.

4. Remove the expansion slot cover on the back panel of the 

computer.

PCI_E.book  Page 1  Thursday, June 25, 1998  12:55 PM