National Instruments 1142 用户手册

•

The following help file for software information:

–

Refer to the DAQ Getting Started Guide packaged with the NI-DAQmx 
software to install your application software, NI-DAQmx driver software, 
and the E/M Series DAQ device to which you will connect the 
SCXI-1141/1142/1143. NI-DAQ 8.3 or later is recommended to configure 
and program the SCXI-1141/1142/1143 module.

Refer to the Read Me First: Radio-Frequency Interference document before 

removing equipment covers or connecting or disconnecting any signal wires.

Refer to the SCXI Quick Start Guide to install the SCXI-1141/1142/1143 
module.

Table 1-1 shows the supported SCXI-1141/1142/1143 terminal blocks. 
Refer to the SCXI Quick Start Guide and the terminal block installation 
guide for more information about the terminal block.

Table 1-1.  Accessories Available for the SCXI-1141/1142/1143

SCXI-1304

Screw terminal block—Mounts on the front of the SCXI-1141/1142/1143 module. 
It includes AC coupling circuitry and ground referencing through a 100 K

Ω bias 

resistor on each channel.

SCXI-1305

BNC terminal block—Mounts on the front of the SCXI-1141/1142/1143 module. 
It is functionally equivalent to the SCXI-1304 terminal block.