brocade-communications-sy rfs6000 用户手册

Interface config commands

12

port-channel

Selects the load-balance criteria of an aggregated port

Supported in the following platforms:

•

Mobility RFS7000 Controller

•

Mobility RFS4000 Controller

NOTE
This command is not supported on the Mobility RFS6000 Controller.

Syntax

port-channel load-balance [src-dst-ip|src-dst-mac]

Parameters

Usage Guidelines

Use this command to configure and set load balance on the aggregated port using 

(config-if) 

static-channel-group

.

Example

The following example creates a channel group 1, with interface ge1 and ge 2:

RFController(config)#interface ge1

RFController(config-if)#static-channel-group 1

RFController(config)#interface ge2

RFController(config-if)#static-channel-group 1

The following example defines the load balance based on the IP or MAC address:

RFController(config)#interface sa1

RFController(config-if)#port-channel load-balance src--dst-ip

RFController(config-if)#

Configuring a port aggregation

Use 

static-channel-group

 and 

port-channel

 for configuring port aggregation. Follow the steps 

below to configure port aggregation:

1. Create a static channel group for port aggregation and associate an interface with it.

RFController(config)#interface ge 1

RFController(config-if)#static-channel-group 1

2. Execute 

 show static-channel-group 

and ensure the virtual static aggregation 

sa 1 has been created and associated with 

ge 1.

load-balance
[src-dst-ip|src-dst-mac]

Sets load-balancing for port channel

•

src-dst-ip – Defines the Source and Destination IP address 
based on the current load balancing

•

src-dst-mac – Sets the Source and Destination MAC 
address based on the load balancing