Fujitsu sparc t5120 用户手册

■

 – Installation times vary, but if you are performing these setup instructions for the 

first time, plan to spend about 45 to 75 minutes to complete all of these instructions. Additional time might be 
required for installing optional hardware and rackmounting kits.

■

 – You configure this rackmountable server through the SP using the built-in serial 

and network management ports, and not through a graphical interface and keyboard. To communicate with 
the SP, you will need a terminal device, which can be a terminal, terminal server, or laptop running terminal 
emulation software. 

■

– During the configuration, you are prompted for time zone and 

networking parameters for your environment. Use 

 to record your configuration information. 

Configuration Information

Select a number from the displayed language list.

Select a number from the displayed locale list.

Select a terminal type that corresponds with your terminal device. 

Select Yes.

Select the network interfaces that you plan to configure. If you are not sure, 
select the first one in the list.

Select Yes or No according to your network environment.

Enter the host name for the server.

Enter the IP address for the selected Ethernet interfaces.

Select Yes or No according to your network environment.

(If subnet was Yes) Enter the netmask for the subnet for your network 
environment.

Specify whether or not to use IPv6. If you are not sure, select No to 
configure the Ethernet interface for IPv4.

Select either standard UNIX security (No) or Kerberos Security (Yes). If you 
are not sure, select No.

Review the onscreen information and change it if needed. Otherwise, 
continue.

Select the name service according to your network environment. 
Note – If you select a name service other than None, you will be prompted 
for additional name service configuration information.

Select the type of domain name configuration according to your 
environment. If you are not sure, select Use the NFSv4 domain derived 
by

 the system. 

Select your continent.

Select your country or region.

Select the time zone.

Accept the default date and time, or change the values.

Enter the root password twice. This password is for the superuser account 
for the Solaris OS on this server. This password is not the SP password.