INSTEON 2633-432 (germany) 用户手册
Page 6 of 14 Rev: 1/21/2014 7:47 AM
Make On/Off Module a Controller
1) Press and hold On/Off Module set button until it beeps
On/Off Module LED will start blinking green
You will have four minutes to complete the next steps before linking mode times out
You will have four minutes to complete the next steps before linking mode times out
2) Adjust responder to desired state
3) Press and hold responder set button until it double-beeps
On/Off Module will double-beep and its LED will stop blinking
4) Test link by tapping or pressing and holding On/Off Module paddle to turn on/off or brighten/dim
Responder will respond appropriately
Note:
-
The link just created is one way. See
another link to keep the two products in sync.
-
If you wish the load to be off when link is activated—such as for an “all off” scene—turn off the
load in step #2.
load in step #2.
Groups
Devices in a group share all the same settings (e.g., on-level, ramp rate). This keeps all group members
synchronized. Every device in a group is both a controller of, and responder to, all the other devices. The
most common example of a group is a 3-way lighting circuit (2 switches). For simplicity, we will assume
that the desired group level is on.
synchronized. Every device in a group is both a controller of, and responder to, all the other devices. The
most common example of a group is a 3-way lighting circuit (2 switches). For simplicity, we will assume
that the desired group level is on.
The following steps will create a virtual 3-way circuit including device “A” and device “B”:
1)
Turn A and B on
2)
Press and hold A set button until it beeps
A status LED will start blinking green
3)
Press and hold B set button until it double-beeps
A will double-beep and its LED will stop blinking
4)
Press and hold B set button until it beeps
B LED will start blinking green
5)
Press and hold A set button until it double-beeps
B will double-beep and its LED will stop blinking
6)
Test by turning load on and off from A and then B
The load(s) and both A and B LEDs will remain in synch
Scenes
Devices in a scene can each have different settings. This provides for advanced scene creation. Software
is recommended for scene management.
is recommended for scene management.
Example of a scene with 1 controller and On/Off Module as a member:
1) Press and hold controller set button until it beeps
Controller LED will start blinking green
2) Tap controller set button
Controller LED will start double-blinking green
1
If either controller or responder LED continues blinking, the addition failed. Tap device’s set button until LED stops blinking and try linking again.